Industrial Water and Wastewater Products

  1. Chopper Pumps: Flygt F-Pump Series

    Flygt F-pumps handle capacities of up to 200 l/s (3200 gpm), with motors from 1.7 to 47 kW (2 to 65 hp) and pumping heads of up to 81m (260 ft).

  2. Liquiline CM444

    Liquiline CM44 is a digital multiparameter controller for process monitoring and control in industrial and environmental applications.

  3. Control Cabinet Solutions

    Build it yourself or have it built: it’s your decision. But we can give you good reasons to decide in favour of “having it built”.

  4. RTP Scrubbers

    Fiberglass scrubbers are used for industrial cleaning and filtering processes

  5. FEDI®-2Rx - Fractional Electrodeionization

    QUA FEDI® Rx stacks for Pharma application features hot water sanitization ability at temperature 80 - 85°C. These stacks have the ability to produce high purity water up to 16 using a patented process with double sets of electrodes per stack.

  6. Corrosion Resistant Dewatering Pumps: Flygt 2700 Series

    Salt water, sludge and slurry, corrosive and abrasive liquids, and effluent with unpredictably high or low pH values. These are tough water transport challenges that require tough pumps. The Flygt 2700 series from Xylem are rugged stainless steel submersible dewatering pumps that handle tough drainage jobs and sludge removal with ease.

  7. Thermo Scientific AquaSensors DataStick AquaChlor Free Chlorine Sensor and Monitoring System
    This free chlorine sensor will measure accurately in processes that are between 4 and 9 pH. When used with the Thermo Scientific AV38 Local display unit and a pH measurement system, measured hypochlorous acid (HOCl) and hypochlorite ion (OCl¯) concentration can be used to determine free chlorine present.
  8. TSS W sc, Suspended Solids InSitu Sensor With A Wiper

    TSS sc probes can measure both online suspended solids and turbidity in one instrument. They cover the total measurement range from the finest turbidity to solids over a wide range.

  9. Amacan P - Submersible Motor Pump With Axial Propeller

    Wet-installed, submersible motor pump with axial propeller in ECB design for installation in discharge tubes, single-stage, single-entry, explosion protection to ATEX II G2 T3.

  10. KLa Systems Slot Injector Aeration System

    The Slot Injector™ System is a superior jet aeration system that is specifically applied to industrial biological treatment processes where fine screening is a standard pretreatment operation in both conventional and advanced air activated sludge applications.